Jump to content
Security Installer Community

Scantronic 9651 Blown fuse have codes


Steve89

Recommended Posts

Hi Chaps

Wondered if you could help.

 

Ive a Scantronics 9651 with engineers codes etc.

 

i recently moved a PR Sensor for decorating and tripped a fuse on the board. While out of use (awaiting fuses) I took the opportunity to remove the keypad and clean the contacts as several buttons were not working properly.  
 

Afterwards I changed the relevant fuse and despite having codes I’m unable to reset my system from a Bell Temper & Aux  DC Fault.   Any tips would be gratefully appreciated.

 

many thanks 

Steve 

Link to comment
Share on other sites

Do you have a multimeter OP?

 

Also send us a picture of your PCB so we can see the exact model (though if it has fuses suspect which one it will be) but good to check.

So, I've decided to take my work back underground.... to stop it falling into the wrong hands

 

Link to comment
Share on other sites

44 minutes ago, Steve89 said:

Hi

Yes, two fuses on the circuit board and the  remaining two all intact.

steve

Do one thing at a time 

 

First disconnect the pirs etc from the 12v aux  , you need keypad on tho of course and link the bell tamper 

 

This should prove panel is working if those faults clear 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.