Jump to content
Security Installer Community

Galaxy flex 0004 aux tamp fault.


Recommended Posts

1 hour ago, Galaxy Tim said:

Hi All,

 

I hope you can help me as I’ve tried all I can think of and not able to get rid of Aux Tamp error to exit engineering mode of Galaxy Flex 20. ~

 

I have two Deltabell external sounders and want to wire both into the Flex 20.  I’ve an internal speaker too. ~

 

 

 

The Deltabells bells are wired into OP1 and strobes into OP2.  OP3 has been used for internal speaker which I’ve not bothered wiring tamper circuit for.  The +12v for deltabells is coming from the left side of the board.  The 0v is wired into the 0v terminal to the right of the three OP terminals.  The deltabells have two tamper terminals which I have wired and brought back to the board on yellow and green.  Yellow is wired into the T beside the OP terminals.  Other tamper terminal from deltabell is wired into 0v.

 

What am I doing wrong?


thanks

Tim

Screw for tamper switch?

Link to comment
Share on other sites

 

Also wire one bell at a time to see if each bell tamper clears 

 

If one doesn't then atleast you know the problem is there , if none do them maybe cable or panel problem or your wiring , 

 

But more likely your wiring stop breath start again and more likely the tamper screw you haven't put it in 

Link to comment
Share on other sites

  • 1 month later...

Many of the flex boards have a little deviation there, if a straight link doesn't solve the 0004 tamper, use a 1K resistor either in series with bell tamper or to link it out directly between T and 0V and it should work just fine. 

Edited by Tjeerd
Link to comment
Share on other sites

2 hours ago, Tjeerd said:

Many of the flex boards have a little deviation there, if a straight link doesn't solve the 0004 tamper, use a 1K resistor either in series with bell tamper or to link it out directly between T and 0V and it should work just fine. 

You mean they have poor manufacturing?

Link to comment
Share on other sites

21 minutes ago, al-yeti said:

You mean they have poor manufacturing?

Haha ... dunno if it was intentional, have seen it on the first few, none ever returned because of the "fix". Wouldn't classify it as poor manufacturing, maybe a glitch? My mind is still boggled over a panel without terminals ...

 

Link to comment
Share on other sites

This has nothing to do with manufacturing quality. It's a country specific setting and depends on the country code / settings selected. OP, if you have picked up a second user panel, set it to factory defaults using menu 51.17 - cold start. If the tamper still exist after that (with the link fitted), then the panel has a fault.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.