sixwheeledbeast Posted August 9, 2019 Share Posted August 9, 2019 3K3 doesn't support multiple devices on one zone would need to be double pole or 4K7/2K2 Quote Link to comment Share on other sites More sharing options...
Shadrack Posted August 9, 2019 Author Share Posted August 9, 2019 the multimeter shows reed 1 at 3.3k and reed 2 on 5.2k. so I'd have to up the reed1 resistor? Quote Link to comment Share on other sites More sharing options...
sixwheeledbeast Posted August 9, 2019 Share Posted August 9, 2019 It appears the international series has allsorts of weird SEOL configurations look in the manual for wiring zones take note of the parallel "zone doubled" config you have to apply this to each circuit you wire this way. If you have moved zones around in the panel this will be setup incorrectly. Quote Link to comment Share on other sites More sharing options...
Shadrack Posted August 9, 2019 Author Share Posted August 9, 2019 I removed all sensors. I've added resistors to all zones (please check the pics if this is right?) and reset to default. I've programmed date and time. This is what I've got now: Quote Link to comment Share on other sites More sharing options...
sixwheeledbeast Posted August 9, 2019 Share Posted August 9, 2019 99 to leave engineers? If so all zones and tamper is active Quote Link to comment Share on other sites More sharing options...
Shadrack Posted August 9, 2019 Author Share Posted August 9, 2019 that is out of engineers. Engineers has all 8 lit up. I tried tamper disable pin on the controller, (has a 3 jumper pinout for Tamper Disable), same thing. Quote Link to comment Share on other sites More sharing options...
al-yeti Posted August 9, 2019 Share Posted August 9, 2019 21 minutes ago, Shadrack said: that is out of engineers. Engineers has all 8 lit up. I tried tamper disable pin on the controller, (has a 3 jumper pinout for Tamper Disable), same thing. So if you disable tampers , then might be as Swb says the seol config and resistor combination? Quote Link to comment Share on other sites More sharing options...
Shadrack Posted August 9, 2019 Author Share Posted August 9, 2019 Well I did nuke config back to defaults so it shouldn't be an issue? also I removed the broken reed and removed the wires so no more 2 reeds on 1 zone. as it is while I type this, all sensors removed, replaced with resistors. Quote Link to comment Share on other sites More sharing options...
sixwheeledbeast Posted August 9, 2019 Share Posted August 9, 2019 May not be setup for resistors as default Quote Link to comment Share on other sites More sharing options...
al-yeti Posted August 9, 2019 Share Posted August 9, 2019 8 minutes ago, Shadrack said: Well I did nuke config back to defaults so it shouldn't be an issue? also I removed the broken reed and removed the wires so no more 2 reeds on 1 zone. as it is while I type this, all sensors removed, replaced with resistors. Put wire links instead of resistors and see if anything changes Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.