GalaxyGuy Posted December 6, 2018 Share Posted December 6, 2018 15 hours ago, dave36 said: That's great many thanks I will give this a go - where does the white tamper wire go - into the 0v ? with the black You've not shown the white wire in your image, so I cannot tell you. Quote Link to comment Share on other sites More sharing options...
al-yeti Posted December 6, 2018 Share Posted December 6, 2018 16 hours ago, dave36 said: That's great many thanks I will give this a go - where does the white tamper wire go - into the 0v ? with the black Your picture doesn't show where white is connected in bell box end Quote Link to comment Share on other sites More sharing options...
dave36 Posted December 7, 2018 Author Share Posted December 7, 2018 Sorry, the white wire goes to the other tamper connection. However with many thanks to you all the bell and tamper are now working fine, the strobe doesn't work but its not too important. I can't see a reason as to why the strobe isn't working unless the wire is in the wrong place or it is set wrong under outputs. Quote Link to comment Share on other sites More sharing options...
al-yeti Posted December 7, 2018 Share Posted December 7, 2018 25 minutes ago, dave36 said: Sorry, the white wire goes to the other tamper connection. However with many thanks to you all the bell and tamper are now working fine, the strobe doesn't work but its not too important. I can't see a reason as to why the strobe isn't working unless the wire is in the wrong place or it is set wrong under outputs. Probably outputs I don't get it why is white going to the other tamper terminal? And where does it go in the panel Quote Link to comment Share on other sites More sharing options...
dave36 Posted December 7, 2018 Author Share Posted December 7, 2018 the white wire goes to a terminal just above the blue wire in the photo and both are marked T. on the panel I've put it in the far right terminal with the 0v wire. Quote Link to comment Share on other sites More sharing options...
al-yeti Posted December 7, 2018 Share Posted December 7, 2018 1 hour ago, dave36 said: the white wire goes to a terminal just above the blue wire in the photo and both are marked T. on the panel I've put it in the far right terminal with the 0v wire. I still don't get it The white wire goes to a tamper terminal Then the other terminal should be like led to zero volts unless your using more than one bell Quote Link to comment Share on other sites More sharing options...
GalaxyGuy Posted December 7, 2018 Share Posted December 7, 2018 If both are marked T, then either take the white back to 0v in the panel too, or just remove the white wire and place a wire link from that 'T' connection in the siren to the black 0v in the siren. 1 Quote Link to comment Share on other sites More sharing options...
dave36 Posted December 9, 2018 Author Share Posted December 9, 2018 thats what I've done and it works - so thanks to you all especially galaxy guy. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.