Jump to content
Security Installer Community

Pyronics enforcer V10 wiring to Deltabell E


Recommended Posts

Hi so I got the Deltabell and tried to wire it to the Enforcer panel. The problem I have is that when I arm the panel the Deltabell goes off!

Please would someone advise me how to wire it including where the jumpers should be. I've set the jumper to SCB mode not sure about the rest. Thanks

Link to comment
Share on other sites

27 minutes ago, Sirenblinky said:

Hi so I got the Deltabell and tried to wire it to the Enforcer panel. The problem I have is that when I arm the panel the Deltabell goes off!

Please would someone advise me how to wire it including where the jumpers should be. I've set the jumper to SCB mode not sure about the rest. Thanks

Can you send pictures how your wired it or drawing or aomething

Link to comment
Share on other sites

I tried to upload a photo but the file is to big so :

deltabell: from the top terminal

white_T

resistor_T

eng hold_ none

stb_yellow

bell_green

12v_red

negative_black also resistor into this terminal linked in to 2nd T above

 

Enforcer panel

Red_12v+

Black_common

Green_bell

Stb_yellow

White_D1

No links or resistors in panel

Frustrating grrr

Thanks

 

 

Link to comment
Share on other sites

IMG_20181016_164504267.thumb.jpg.e098b37c0153124f4490e4def1bb7136.jpg

3 hours ago, Sirenblinky said:

I tried to upload a photo but the file is to big so :

deltabell: from the top terminal

white_T

resistor_T

eng hold_ none

stb_yellow

bell_green

12v_red

negative_black also resistor into this terminal linked in to 2nd T above

 

Enforcer panel

Red_12v+

Black_common

Green_bell

Stb_yellow

White_D1

No links or resistors in panel

Frustrating grrr

Thanks

 

 

 

IMG_20181016_164351110.jpg

Link to comment
Share on other sites

Also I think your white wire needs to go to z33 and z33 is programmable in menu as a bell tamper , z33 normally has the resistor on it in series so like white wire connects to resistor and then resistor goes into z33 , resistor mostly goes in bell , but your in bench DIY unit won't matter 

 

Been a while since I did this , isn't D- , zero volts so that's where the black would go ?

Edited by al-yeti
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.