Jump to content
Security Installer Community
Bigmatt

Total RF Failure

Recommended Posts

Hi

 

I have a Honeywell galaxy 2-12, C012 Alarm system (ex ADT). My control panel is showing "RF Fail" for all 7 of my detectors, so i had a look at the install manual online and that lead me to check the RF Portal (C079-2) when i check this the red LED is flashing steadily. I guessing this is the issue but just wanted to check, firstly if this is the fault i.e. failed FR portal and secondly does a new RF portal need setting up/pairing or is it just a straight replacement.

 

Thanks in advance,

 

Matt.

thumbnail_IMG_9891.jpg

thumbnail_IMG_9892.jpg

Share this post


Link to post
Share on other sites

The Rf Portal should be flashing but depends on the rate

 

0.1 ON / 0.9 OFF Normal communication

OFF No d.c. supply

1.5 ON / 1.5 OFF RIO has not been configured into system

0.2 ON / 0.2 OFF RIO has lost communication with system

0.9 ON / 0.1 Very poor communications

 

If you have access to the programming menu check RF module comms in 61-3


www.nova-security.co.uk

www.nsiapproved.co.uk

No PMs please unless i know you or you are using this board with your proper name.

Share this post


Link to post
Share on other sites

Module probably needs power cycled. I've seen this happen, but quite rare. If not under contract and you have engineering code, it's easier to power cycle the whole system (batt and mains disconnect momentarily), then correct the time and date.

Share this post


Link to post
Share on other sites
3 hours ago, Bigmatt said:

Thanks Galaxy Guy this did the trick just need to reset the date and time any ideas

From managers menu option 41

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.