Jump to content
Security Installer Community

Call Installer Scantronic 9651 Cooper Security 9930


nvturner

Recommended Posts

I have a yellow light on the control unit that states 'call installer'

The log also reports "Tamper Z07 Rstr" which is the remote input panel

 

This was after the property lost power and was hard-reset at the fuse box.

 

Any suggestion is welcome

Link to comment
Share on other sites

Sounds as if you have a faulty battery, the tamper has been 'restored' so could be a PIR or DT that shows 'tamper' until

it's properly powered up for a few seconds, I think some Riscos are known for this.

 

I would get someone in for a full service and battery change.

So, I've decided to take my work back underground.... to stop it falling into the wrong hands

 

Link to comment
Share on other sites

Besides calling a security engineer in place of the actual installer (whom has ceased to trade) is there anything that could be done in the mean time?

 

When you enter the user code it beeps, tells you of problems but doesn't allow the setting of the alarm.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.