Jump to content
Security Installer Community

On Board Kp?


dylan1055

Recommended Posts

is a panel with an on board key pad compliant ?

 

I was under the impression hat the panel had to be off the entrance/exit zones ?

if the kp on the panel is used as the primary method of set/unset then the zone the panel located in would have to be on the entrance path ?

 

 

Link to comment
Share on other sites

This is what I got told the other day is the CIE to be installed in the protected area, not visable from outside of the protected premises.

Someone did ask about combined keypad and CIE and was told this would be ok to fit on entry route but is down to the risk assessment.

 

I assume its in the BSEN50131 or PD6662

 

but looking at at lest two places i have been in one CIE was mounted above the entrance door with the keypad next to the door. and the other was mounted on the right hand wall as you go in with the keypad on the left. So i would think this might be something thats been put in to the regs in the last few years.

 

But I could be wrong and shot down in flames and buried alive. :-

Link to comment
Share on other sites

  • 3 months later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.