Alarm Protection Posted August 2, 2014 Share Posted August 2, 2014 If I remember these panels right you have a tamper problem on one of the zones. The panel on board tamper will not reset untill fixed. Was there any tamper connected to the board? U taken link out? A picture of the wiring if you can. Quote ! Link to comment Share on other sites More sharing options...
omegauk Posted August 2, 2014 Author Share Posted August 2, 2014 when the panel came this morning, there was no bidges in the 8 zones. Only 1,2,and 3 zones are been used now. I have replaced all the wiring the same way it came out. the sparkie used blue/white for the tampers on the wiring and I replaced them Quote Link to comment Share on other sites More sharing options...
Alarm Protection Posted August 2, 2014 Share Posted August 2, 2014 I would start from scratch tbh. All links on tamp then start to connect cables. Quote ! Link to comment Share on other sites More sharing options...
omegauk Posted August 2, 2014 Author Share Posted August 2, 2014 Thank you for your advice and I am going to do as you say on Monday, at the back of my mind I knew I should of bridged all zones before starting. but it was 15 years since I fitted one lol Quote Link to comment Share on other sites More sharing options...
Alarm Protection Posted August 2, 2014 Share Posted August 2, 2014 No comment! Quote ! Link to comment Share on other sites More sharing options...
datadiffusion Posted August 2, 2014 Share Posted August 2, 2014 the sparkie used blue/white Are the other colours in the cable orange/white and green/white perchance? Quote So, I've decided to take my work back underground.... to stop it falling into the wrong hands Link to comment Share on other sites More sharing options...
Cubit Posted August 2, 2014 Share Posted August 2, 2014 Are the other colours in the cable orange/white and green/white perchance? That rings a bell Quote Link to comment Share on other sites More sharing options...
datadiffusion Posted August 2, 2014 Share Posted August 2, 2014 Constantly! Quote So, I've decided to take my work back underground.... to stop it falling into the wrong hands Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.