al-yeti Posted December 30, 2013 Share Posted December 30, 2013 hi anyone know the pinouts for header so i can connect? rss i dont have a lead for it i can make one i guess Link to comment Share on other sites More sharing options...
al-yeti Posted December 30, 2013 Author Share Posted December 30, 2013 come on, all experts sleeping in lol Link to comment Share on other sites More sharing options...
matthew.brough Posted December 30, 2013 Share Posted December 30, 2013 A case of most of the experts don't play with such baby panels. Most experts probably using SIA rather than pins negating the need for the lead . . . www.securitywarehouse.co.uk/catalog/ Link to comment Share on other sites More sharing options...
al-yeti Posted December 30, 2013 Author Share Posted December 30, 2013 ok but i dont want to have to reset the whole panel to get the codes out, so you suggest just direct connect to the tel port? Link to comment Share on other sites More sharing options...
matthew.brough Posted December 30, 2013 Share Posted December 30, 2013 Your taking it over and you you want to crash the user/engineer code? If so there is an easier way to do that. www.securitywarehouse.co.uk/catalog/ Link to comment Share on other sites More sharing options...
al-yeti Posted December 30, 2013 Author Share Posted December 30, 2013 yes correct, i dont know the other way but i have software easy enuf on the g3 dimensions etc but havnt done it on these before, Link to comment Share on other sites More sharing options...
matthew.brough Posted December 30, 2013 Share Posted December 30, 2013 Just realised this thread is public. We don't give out this info in public forums for obvious reasons. If you apply for trade status http://www.thesecurityinstaller.co.uk/forum-trade-access.html you can get the answer on the raft side and you'll see many more posts that you currently can't see. www.securitywarehouse.co.uk/catalog/ Link to comment Share on other sites More sharing options...
MrHappy Posted December 30, 2013 Share Posted December 30, 2013 hi anyone know the pinouts for header so i can connect? rss i dont have a lead for it i can make one i guess IIRC the factory lead is needed as its neither 232 or 485 at the header pins, Mr Veritas God Link to comment Share on other sites More sharing options...
al-yeti Posted December 30, 2013 Author Share Posted December 30, 2013 i sent you a pm Mathew, ok i assumed the rss uses 232, because the programming header uses the rss Link to comment Share on other sites More sharing options...
Cubit Posted December 30, 2013 Share Posted December 30, 2013 Seems even diynot won't divvy the info up. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.