Jump to content
Security Installer Community

What Detector Or Device To Put On Automatic Glass Sliding Door


Recommended Posts

  • Replies 35
  • Created
  • Last Reply

 

Yes it is a single sliding, final exit door.

 

 

see....

 

don 't listen to this lot, don't waste your time trying to stick anything on, it will look wan  k, every alarm engineer who walks past will think you're rough and you'll be back every 6 months sticking the thing back on again.

Link to comment
Share on other sites

if a wireless contact is ok, attaching with epoxy should be fine. their are different types with differing properties and cost, but double sided is no good for a permanent solution.

i was asked to instal two maglocks on z&l brackets to double glass doors, using an eppxy supplied by Noralsy for the job. i had massive doubts so clauses and caviates that covered me for next doors cat dying, spent a whole day on just fixing using cramps to get pressure and hold

being a veteran of araldite and super glue failures, to my complete surprise it held, only for three weeks later i was asked to re-move and fit to another set of doors lol!

part of those z&l brackets are still stuck to them first doors today :).

^^^^What he said, and if it does stick you will get the blame for the mess left when it needs replacing.

why would that be? the base is not changed and thats the bit what is stuck.

If you think education is difficult, try being stupid!!!!

Link to comment
Share on other sites

if a wireless contact is ok, attaching with epoxy should be fine. their are different types with differing properties and cost, but double sided is no good for a permanent solution.

i was asked to instal two maglocks on z&l brackets to double glass doors, using an eppxy supplied by Noralsy for the job. i had massive doubts so clauses and caviates that covered me for next doors cat dying, spent a whole day on just fixing using cramps to get pressure and hold

being a veteran of araldite and super glue failures, to my complete surprise it held, only for three weeks later i was asked to re-move and fit to another set of doors lol!

part of those z&l brackets are still stuck to them first doors today :).

why would that be? the base is not changed and thats the bit what is stuck.

System change?

Base damaged?

New model dc?

Probably get something to remove the old glue tho

Link to comment
Share on other sites

System change?

Base damaged?

New model dc?

Probably get something to remove the old glue tho

We are talking a door contact, surely not an issue against uhly cable ir using a beam? but if you want future proof options then mount contact using aluminum angle glued to glass

If you think education is difficult, try being stupid!!!!

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.