Jump to content
Security Installer Community

Texacom Premier 24 - Part Arm No Bell


jaykay1975

Recommended Posts

Hello all

I installed my wired Texecom Premier 24 last year, and since decided to use the feature that allows me to set the alarm when going to bed. So all has gone well so far, except when the alarm is activated the outside bells & strobes dont sound, the only sound I get is from the keypad / panel. I've been googling and going through the Install manual for the past few hours and given up looking for the answer the hard way!

So the question is, when I Part Arm my system, how do I get it to sound the bell outside?

(By the way everything works perfectly when it is fully armed, all bells & lights).

Thanks in advance for anyone who stops and replies with advice. (my next stop is the Texacom support line).

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.