Jump to content
Security Installer Community

Viper Glx Problem Scantronic 9751 Panel


bsbsys

Recommended Posts

Hi Everyone,

Please can you help I have 2-3 Viper GLX's on one Zone connected to Scan 9751 Panel, Due to constraints with using existing wiring and plaster they are wired with 4 core. Please see the diagram i have attached to explain the best i can, i have wired the alarm in series and -ve terminal is connected to the OP3 at the panel as Shock reset going by the manual. I have been told this its possible to wire in this way.

Problem i am getting is that when i arm the system it states the Zone is open (only with the shocks) it arms successfully however and if I bang them twice they do correctly set the alarm off

Any ideas on improvements or any links i have missed out?

Many Thanks

B

post-37857-0-16232000-1327511670_thumb.j

Link to comment
Share on other sites

Its because the op toggles to clear any latch everytime its set, longs its sets its OK. How old is the panel?

You could have used inertia sensors as 9751 have shock analysers on ccts 1-4 off memory. You could have put the two on separate circuits.

Not a fan on doors though as when the postie knocks...... ;)

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.