Jump to content
Security Installer Community

Locked Out Of Panel


Tallbloke

Recommended Posts

I was doing a maintenance on a CD95 when I found the memory card sitting on the battery. I fitted the card, formatted it and uploaded the panel data. When I came out of engineer, I couldn't get back in. I tried the default code but that didn't work either. The user codes where there but the descriptors have gone. The zones go into alarm so at least they haven't been spared out. I'm dreading having to default the panel. Will a downpower clear it or am I looking at a default?

Link to comment
Share on other sites

Don't know yhis kit, but Access via PC lead might get you out of jail to set up engineer code.

Can you upload your memory 'dump' to a spare Panel? Then reconfigure and over write?

Arfur

If you think education is difficult, try being stupid!!!!

Link to comment
Share on other sites

Possibly, if I can get into engineer.

I believe this panel's bigger brother can be accessed via a laptop but I'm told nobody in our co. has the software. I'll try Aritech tomorrow now that I found the new number. (They're now part of UTC).

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.