Jump to content
Security Installer Community

Disabling Tampers


BAUERJAN

Recommended Posts

Hello everybody,

I have a NEXUS 8 alarm system. The standby battery is worn out and I want to replace it.

If I enter the 'Engineer Code' on the remote control panel, will this disable the tamper functions?

I presume that I will then be able to remove the alarm panel cover without activating the system?

Is this correct?

I also want to check the remote Bell Box. If I have entered the 'Engineer Code, will I be able to remove the Bellbox cover without the bell going-off?

Many thanks,

Jimmy

Link to comment
Share on other sites

if you have the engineer code and the system is fully unset then yes most panels will then ignore tampers.

However the external bell should still ring as the mode of the panel is irrespective to the bell.

securitywarehouse Security Supplies from Security Warehouse

Trade Members please contact us for your TSI vetted trade discount.

Link to comment
Share on other sites

if you have the engineer code and the system is fully unset then yes most panels will then ignore tampers.

However the external bell should still ring as the mode of the panel is irrespective to the bell.

@ redbull

Many thanks for your help.

Jimmy

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.