Jump to content
Security Installer Community

Texecom Sounder Strobe Fault


minime

Recommended Posts

Does sound like a Texecom bell,

If the LEDs are (were) indicating Engineer hold-off then it could be a problem with the panel invoking this mode, however more likely its the bell box at fault. As for the strange sound with the strobe flashing, this is likely a problem with the PCB in the bell and needs replacing

Hope this helps,

Regards, Ranger.

The above is my personal opinion and not that of my employer or anyone else.

Link to comment
Share on other sites

Many thanks for all your posts, all is now sorted

The installation company have advised that there were a batch a while ago that when the temperature went below -2 ( never gets much above in Scotland! )that the bellboxes would fail.

It is being replaced FOC :)

Link to comment
Share on other sites

Many thanks for all your posts, all is now sorted

The installation company have advised that there were a batch a while ago that when the temperature went below -2 ( never gets much above in Scotland! )that the bellboxes would fail.

It is being replaced FOC :)

atleast gardtec was -7 ;)

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.