Jump to content
Security Installer Community

Salamander Door Retainers


Recommended Posts

Guest Cerberus NI
No sorry.

Fitted what feels like a million dorgards though if it's any help .

C.

:)

Ahh,but there's no central monitoring with the dorgards and they are dependant on the acoustic volume of the sounder to set it off.

Link to comment
Share on other sites

Ahh,but there's no central monitoring with the dorgards and they are dependant on the acoustic volume of the sounder to set it off.

You get them with a control unit now for noisy enviroments.

http://www.safelincs.co.uk/product.php?xProd=339&xSec=88

EMS make them under licence to Dorgard.

I prefer the stand alone acoustic dorgards you can charge for a site visit and audibility test 1st :yes:

C.

:)

Link to comment
Share on other sites

You get them with a control unit now for noisy enviroments.

http://www.safelincs.co.uk/product.php?xProd=339&xSec=88

EMS make them under licence to Dorgard.

I prefer the stand alone acoustic dorgards you can charge for a site visit and audibility test 1st :yes:

C.

:)

hmmmm trouble is i just don't like the mechanical bits.... we need to fit some magnets in a school and dorguards will last about as long as the average extinguisher !

Link to comment
Share on other sites

I must admit i am confused - I have always been under the impression that datonte' door hold units should release as fail safe if there is a fault on the fire alarm system, Being connected to control output signal only, not alarm signal, as all interface should be, or have BS: Standards been relaxed.

Also localised detection should installed either side of a door that has devices fitted ?

Link to comment
Share on other sites

I must admit i am confused - I have always been under the impression that datonte' door hold units should release as fail safe if there is a fault on the fire alarm system, Being connected to control output signal only, not alarm signal, as all interface should be, or have BS: Standards been relaxed.

I'd need to read 5839 to clarify but I don't see an issue using Dorgards.

What I would say is Dorgards are approved and fitted nation wide & surely fire risk assessment decides since 10/2006.

This is the legislation & FAQ's page of their website - http://www.dorgard.com/DorgardLegislationAndFAQs.asp

Also localised detection should installed either side of a door that has devices fitted ?

That would depend on the category of alarm IMO i.e no difference in internal room doors on an L4 for example

C.

:)

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.