Search the Community
Showing results for tags 'g2-20'.
Hey all, just in the process of rejigging the alarm, and it's been a while since I've tinkered with the wired stuff... I want to switch a single PIR for a Shock on my G2-20... Forgetting the 'quality' of the wiring, how would this transplant over to the Viper? And resister location?? Thanks in advance!
Hi All Hope all is well. I hope this is not a stupid question. I thank you in advance. I've purchased a Honeywell galaxy ethernet module. I have a query in relation to powering down the panel prior to installing it. When i have put the panel into engineers mode, and disconnect the fused spur, i will have to remove the backup battery power also. Will the external bellbox sound, when the backup battery power is removed? Appreciate your reply. Great forum. Regards Zemme
Hi Folks Hope everyone is well. I am looking for a bit of advice. Any advice is appreciated. I currently have a standard honeywell door contact sensor on my front door and patio door. It is already wired up & working fine. I want to upgrade them to Viper GLX Shock Sensor With Contacts. Do i simply cable the new Viper exactly the same as the existing sensor? Or do i need to use extra wiring back to the panel? Thanks in advance - Enjoy the weekend. Regards Zemme
Hi All Hope you are all well. I hope i am posting my query on the correct thread. I would dearly appreciate any advice that is provided for my query. I recently had a Honeywell Galaxy G2-20 installed by my uncle. He has only installed a couple of these Honeywell alarms previously, however he is stumped on a certain issue. My setup is as below. 1 X Honeywell Keyprox MK7 CP-038 Keypad (Address 0, Downstairs) 1 X Honeywell Keyprox MK7 CP-038 Keypad (Address 1, Downstairs) 1 x Honeywell RF Portal (Address 4) The issue that i currently face is that the only functioning keypad is downstairs. From an overall perspective, the alarm functions fine with the keypad installed downstairs. I can set & unset the alarm fine. The issue is that the upstairs keypad and the rf portal do not function when connected to the power supply. The upstairs keypad led is rapidly flashing with a green led and flashes with many stars, eg. ***************************************. The keypad was beeping when installed, however the esc key was pressed to silence the audible keypad beeps. The rf portal is not connecting correctly via the data line. I have come to the conclusion that the communication link has not been wired up correctly. The current setup has the A & B from the keypads & rf portal connecting directly on to the A & B data bus on the G2-20 panel. It is not daisy chained. Are my assumptions correct? Also the last connection (rf portal) does not have a 680ohm resistor connected between the A & B. Should the setup be like this? 1. Alarm Panel Data Bus "A" -> Keyprox Keypad Downstairs Data Link "A" -> Keyprox Keypad Upstairs Data Link "A" ->RF Portal Data Link "A". 2. Alarm Panel Data Bus "B" -> Keyprox Keypad Downstairs Data Link "B" -> Keyprox Keypad Upstairs Data Link "B" ->RF Portal Data Link "B". 3. RF Portal Data Link "A" -> RF Portal Data Link "B" (Looped Using A 680ohm Resistor). I appreciate your time to reply. Best Regards Zemme