Search the Community
Showing results for tags 'flex 20'.
-
Hi. I've been testing my Galaxy flex 20 still and everything seem to be working fine now and arms/disarms fine etc. Can I edit what is displayed on the keypad banner at the moment it's just showing the model name and number. And also when the alarm is armed is there a way of having it display on the keypad that it's armed ? I've looked through the manual but can't see any mention. Cheers
-
Hi Gents, i have learned a lot from the forum and want to thank you, but I am also after your help for something I cannot find the answer to. I have a Honeywell Flex 20 and it has 2 RF Portals attached, they are both blinking to indicate that they are communicating with the bus, if I pull the tamper link they both pop up on the keypad with their correct addresses. However, I am only seeing the range of addresses for 1 of the portals when I try to connect wireless devices... any ideas? Thank you in advance. Neil
-
Hi bit of a noobie to alarms but have a good general understanding. I've purchased and installed a Galaxy Flex 20 panel with the RF portal, PIR's are all wired, shock and door sensors run over RF. I have two problems, one of the PIR's constantly keeps triggering the alarm randomly when set, it's located in the living room facing the rear french doors, after speaking to some people they believe the sensor is faulty. Could it be this or the sensitivity, I have no pets. Second issue is that I realised after buying and installing it, the system is designed to dial out to monitoring centr