Leaderboard

Okay, checked this out on the Flex with a RIO. So what you need to do is configure the virtual RIO in the RF portal so that it doesn't take any addresses up. Ie. No virtual RIO enabled. Then you can configure any of the 20 hardwired zones as either wireless or hardwired. The easiest way to do this is to: 1. Enter engineering mode and remove both portal and rio from the system. 2. Exit engineering mode and remove the devices from the config when prompted. 3. Set the RIO address to 2 and add back to the bus. 4. Enter eng mode and menu 72 to detect the device. 5. Add the portal and then menu 72 to detect it. Now the portal should show on its bus, but with no virtual RIO's addressed (menu 51.60.1 shows the virtual RIO - note my typo earlier when I said it was 56). If you want to do this without removing devices, you need to use 51.60.1 to diable the virtual rio, then the hard wired RIO can be enumerated onto the bus.