Jump to content

Recommended Posts

Hi All, 

Needed a bit of advise. Had a new aluminium front door installed. The previous wooden door had a flush contact sensor. I've attached a photo. I needed a new sensor that would be on  the surface rather than flush. Not quite sure what to get. Originally it was a CQR MAXIMAL FLUSH CONTACT FC504 O.G 23MM. Can anyone point me in the right direction on what to replace it with? 

 

Will this do the job?

 
Any help will be greatly appreciated. :lol:
 
Titch

Screenshot_20180430-215833_WhatsApp.jpg

Share this post


Link to post
Share on other sites

Any type of contact could work If you can fit within the operational gap but the push in "pencil style" are normally the most aesthetic on alu. I keep a few GE ones handy (1078).

A picture of the door maybe handy if you need more advise on a surface fit.

Share this post


Link to post
Share on other sites

Thanks for the response. I definitely think the flush ones are the way to go. Maybe it's time for a full install. The system is a bit dated anyhow. I think I need to get the professionals in. :rolleyes:

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Recently Browsing   0 members

    No registered users viewing this page.

×