Jump to content
Security Installer Community

Ts2500


BeechStu

Recommended Posts

Have you powered the whole system down and back up?

i have done this before to clear network errors.sounds like you may have some interference or a ****** panel, have you tested for induced AC and checked the cable insulation?

 

please note though, not all TS 2500 come back to life from a full power down

lucky for me, mine are immortal

Link to comment
Share on other sites

The psu was a major problem on these does not like to keep 17 ah battery fully charged.  it uses the battery  like a giant smoother capacitor if the panel powered any thing other than the sas or redcare   it pushed it to its limit so  had to always power network and detectors from separate psu  

Link to comment
Share on other sites

17 hours ago, sixwheeledbeast said:

You'd normally get the fault tone with the battery removed not full alarm.

I thought maybe thats what he meant, customers often confuse tamper tones with alrm going off 

Not only that it will go off again shortly after resetting it 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.