Jump to content
Security Installer Community

melcom st6000


Guest bramwec

Recommended Posts

Guest bramwec

sorry completely no idea what im doing but can anybody tell me how to change my security code on the melcom st6000 as I have lost the manual please ?

Link to comment
Share on other sites

This manual can be downloaded from

http://groups.msn.com/UKSecurityPanels

ST6000 - USER INSTRUCTIONS

TO SET THE ALARM:-

Enter your four digit code

TO UNSET THE ALARM:-

Enter your four digit code

TO PART SET THE ALARM:-

Enter your code and press 'set'

TO SILENTLY SET:-

Press 'Prog' during exit time

TO OMIT A ZONE/S:-

Press 'Omit' during the exit time,

then the zone numbers, then 'Set'

TO RESET DURING/AFTER AN ALARM:-

Enter your four digit code and press 'Reset'

CUSTOMER PROGRAMMING

TO TEST SYSTEM, SOUNDERS AND STROBE:-

Press 'Prog' and enter your four digit code

Then press '0'

Press '1' to test the strobe, 0 to stop

Press '2' to test the outside sounder, 0 to stop

Press '3' to test the high volume internal sounder, 0 to stop

Press '4' to test the low volume internal sounder, 0 to stop

Press '5' to walk test the system, 0 to stop

To exit test mode press 'Reset'

TO CHANGE CUSTOMER CODE:-

Press 'Prog' then your four digit code, then press '8'

Enter your new four digit code

Link to comment
Share on other sites

  • 4 years later...

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.