Jump to content
Security Installer Community

Zone omit


Recommended Posts

Yes omitting a circuit to set the system. Basically a fairly large system has just gone in and the engineer didnt give any of the zones the omit attribute. There have been a couple of issues with devices and the user couldnt set the alarm due to them showing  permanently in the open state.. I changed the zones to allow omit [as I have always done] but was told after your not allowed on grade 3.

Link to comment
Share on other sites

1 hour ago, Amps said:

Zone omit not normally allowed due to insurance policy.

 

Its down to the company.

 

omit signal must be sent to ARC if the system rearms and force omits a circuit, but its open to interpretation, but send omit if any circuit is omitted by user.

www.nova-security.co.uk

www.nsiapproved.co.uk

No PMs please unless i know you or you are using this board with your proper name.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.