Jump to content
Security Installer Community

Baud Rates


danlad1980

Recommended Posts

was asking as I have been asked to look at a DM2060 PTZ which is using a BBV CTI/1 coax telemetry interface. there is 3 of these cameras and the other 2 work fine but this one will not respond to any commands. the cable is RG59, picture is clear, think the cable is over 250 meters but there is about 30 meters of the cable in the building so was thinking of moving the interface to the point just before the cable gose under ground.

any view or ideas from you guys would be a big help.

Link to comment
Share on other sites

Depends, slower speeds are better with interference. But no need for high speed.

+1

nothing on a camera requires fast speeds to control it, more chance if locking up at the higher rates. it won't pan, tilt or zoom any faster using higher rates, or pump more water through the screen washer either.

If you think education is difficult, try being stupid!!!!

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.