Texecom Bell Box

[Guest james callaghan]

Hi, just set up veritas R8 system, when carried out a part set and activated the system, then performed a reset the External Sounder/Bell box still activated and can't turn off. Checked wiring at both sides both ok. Any ideas? Many thanks

[PeterJames]

Hi, just set up veritas R8 system, when carried out a part set and activated the system, then performed a reset the External Sounder/Bell box still activated and can't turn off. Checked wiring at both sides both ok. Any ideas? Many thanks

Its either wired incorrectly or a faulty bell how have you wired it i.e. what terminal bell to what terminal panel?

Of course it may be a panel fault is the panel still outputing once you have reset? and lastly make sure the strobe output is not in anyway connected or shorted with the bell trigger

[arfur mo]

What siren have you used would also help

Arfur

[9651]

Is the panel in day? Do you have a return tamper voltage from the bell unit. Either the units in tamper, or you have the trigger of the unit wired into the 0v of the bell (done that before!)

[james.wilson]

as above need to know what sounder you have. Some sounders have a high security trigger mode that might need a pull up resistor in the trigger if enabled.

[FASTCAR]

Make sure you havent inverted the bell output by mistake (options 01 , 6 )