Search the Community
Showing results for tags 'scantronic 9943 keypad'.
Found 1 result
-
Hi I installed this system at home around four years ago. It is based around a Scantronic 9651PD panel, has Honeywell PIRs and uses two Scantronic 9943 keypads (which use proximity fobs). All has been well with this system (since my last post about it) but I had two unusual occurrences earlier this morning. While at home with the system Unset, I got a keypad tamper alarm. I cancelled this but, three minutes later, I got a second keypad tamper alarm (same keypad). I cancelled this and, since then, all has been well (for almost an hour, at the time of writing). I have checked the keypad but can see nothing untoward that might have caused this, nor has there been anything going on near the keypad either. The relevant part of the log reads as follows: 11.25.31 KO1 Tamper 11.25.34 Kpd KO1 Restr 11.28.07 KO1 Tamper 11.30.42 Kpd KO1 Restr 11.32.45 Reset The only additional observations I would make here are that on both occasions, I cancelled the alarm within about 20 seconds but I note that the first tamper event seemed to restore within three seconds while the second tamper event took over two and a half minutes to restore. As usual, any thoughts on what might have caused this and any remedial action that may be necessary would be much appreciated. Thanks.
