Search the Community
Showing results for tags 'scantronic 9448+'.
Found 2 results
-
I'm trying to connect a new Scantronic 9448+ control panel to a remote 9427 control pad. I have installed a loop on the anti-tamper connections but the pad permanently lights its anti-tamper indicator and won't arm. I've connected a single magnetic door switch to the EE entry/exit connectors (it's for an outbuilding with a single door). I haven't connected a strobe/siren box or any backup batteries at all yet. There are 4 connections between the control box and the remote pad : 12V to 12V 0V to 0V DATA to DATA CLK to CLK (Even I couldn't get these wrong!) After powering it up I can silence the internal sounder by entering the default user code and I can get into the programming mode and set all of the six zones as 'Not used'. But the Tamper indicator still glows and I'm unable to set the alarm without triggering the sounder. If anybody can offer any advice I'd be very grateful. -
Came home last night to my Alarm beeping intermitentley about every 10-15 seconds. Then started going off. I have no power to the key pads at all. Checked online for help and have replaced a blown fuse but still no power to keypads, Disconnected the mains and the battery inside but alarm has still been going off for over an hour. When i reconnect the battery it stops for a while so was able to get some sleep but going off again. Have tried local alarm companies but as i dont have a contract with them thy wont come out until 8-12 am. Help my neighbours are ready to lynch me!
