Jump to content
Security Installer Community

fireyfox

Newbie
  • Posts

    1
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

fireyfox's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. Hi I'm hoping someone my have seen this before and could share some knowledge. I have an Elite 88, I would like to upgrade the firmware. Whenever the flasher cable is plugged into the programming port, both the heartbeat and Txt/Rxt leds do not illuminate on power up. The cable is plugged up correctly I believe, the red ident matching the arrow bottom left of the 10 pin header. Ribbon cable not faulty as no problems when connected without flasher pcb attached. This is where you say it's normal don't worry and get flashing! I've tried flashing and the software responds board failed to respond correctly. With the flasher cable removed, on power up heartbeat and tx/rx respond as expected. Any ideas?
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.