Hi, I have an accenta 8 system, and with rendering work being done on the house decided to replace an old bell box with a Reson 8 bell box. The old bell box simply had two wires providing power to the speaker, tracing this out showed it went to bell + and bell - on the panel. Before installing the bell box outside I tested it internally to check I could wire it up correctly, using another length of cable to SCB and Bell connectors on the panel and all was good.
However when I wired it up outside, it set the system to tamper. I discovered several junction boxes in the way, which I've wired up to make sure all the SCB connections flow to the new bell box as these weren't present before. The system now fails to get out of tamper mode, even though I've cleared the NVRAM. I've even removed all the zone and PA connectors as mentioned in the engineer manual to diagnose what is wrong but the system still fails to get out of tamper mode, when powering up. Fuses are all present and have not blown, how can I proceed? Many thanks in advance.